| Author |
Message |
< WinPCSIGN Software ~ How do I get rid of panels when plotting? |
| dingfangle |
 Posted: Mon May 19, 2008 5:10 am |
 |
|
|
Joined: 10 May 2008
Posts: 2
|
I know this has been asked befor but, but I am trying to figure out how to make my cutting area to the max width of my plotter. I have a 48 inch plotter and when I open the cutting screen for a large item I get multiple panels. I read in one of the other topics that all you need to do it change the "vinyl size" I assume this means the the box in the lower right corner of the cutting tab? Is there a certin way the info needs to be entered there? Every time I try it doesnt work. I have tryed to cut the given size numbers only and enter my own, I've tryed to use an "X" between the numbers...ect. usualy the program fails and I have to re-open it and start over again. any help would be great.
Thanks |
|
|
| Back to top |
 
|
| Ivan |
| Posted: Wed May 21, 2008 6:57 pm |
|
|
|
Joined: 19 Apr 2007
Posts: 352
Location: Montreal
|
Panels are generate by Material option from Cutting Control panel. So if you have 48 inches cutter and the vinyl put in the cutter is 48, you must write 48 on material option. You can also select Save material from Options on Cutting Control Panel. This function will force your document to X 0 and Y0 position start point
You can also watch this movie:
http://www.signmax.us/phpbb2/viewtopic.php?t=387 |
_________________
Ivan Polanco, Sales manager/Support
Signmax.us Profesionnal signmaking ressources |
|
| Back to top |
 
|
| dingfangle |
| Posted: Thu May 22, 2008 3:15 am |
|
|
|
Joined: 10 May 2008
Posts: 2
|
exactly what I was looking for thanks for the help  |
|
|
| Back to top |
|
|
|
