Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  Vinyl Cutter sign making   ~  CT-635 cutting issues

jechambe
Posted: Sat Nov 18, 2006 6:39 pm Reply with quote
Joined: 18 Nov 2006 Posts: 2
I have a PCUT CT-635 and running WinPCSIGN Letter 2005
Weed Value 0.15, Knive Offset 12, using a fresh 45 degree blade


Been running the plotter and software w/o problems for over a year. now i have run into a series of problems and hoping someone can help

i usually cut outlines of graphics so its basically a shape with an outline shape .04cm wider.

lately, whenever i cut any shape, it will usually do the inside shape fine and then cuts about half the outside shape. its very inconsistent and since it happens on an outline i believe the blade position is too similar for it to be a teflon strip problem (i did replace it by the way)

currently, the plotter is set to a pressure of 97 and cuts cleanly when put in the test cut mode.

any help would be greatly appreciated.

-Jim
View user's profile Send private message
Ivan
Posted: Thu Mar 13, 2008 5:06 pm Reply with quote
Joined: 19 Apr 2007 Posts: 352 Location: Montreal
i think your cutter work very well!!!

_________________
Ivan Polanco, Sales manager/Support
Signmax.us Profesionnal signmaking ressources
View user's profile Send private message Send e-mail Visit poster's website

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum