Signmax.us ~ View topic - Orientation problem

Author

Message

< WinPCSIGN, error messages and solution ~ Orientation problem

newby

Posted: Sun Apr 16, 2006 12:08 pm

Guest

Quote:

How to make it the same as you see in the computer? It cut/plot vertical when the computer show horizontal? Please advise.

ivan

Posted: Sun Apr 16, 2006 3:45 pm

Guest

It depend of the ploter and job size!
If you have a 48 inches plotter and your job is 46 inches wide you can apply the rotation (90) option. And if you have 24 inches plotter and your job is 22 inches wide, you can also apply the Rotation option, from Cutting Control Panel or from your Plotter.

But if you have 24 inches plotter and your job 30 inches wide, you can not apply Rotation option, because your job is bigger that your vinyl roll ( 24 inches) so in this case you dont have choice you must cut to the unroll of vinyl direction.

Attention: order to apply this exemple you need to set the head of the plotter on the right corner of the plotter.

All times are GMT

View next topic View previous topic Page 1 of 1 Signmax.us Forum Index ~ WinPCSIGN, error messages and solution

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum