Author |
Message |
|
DECAL MANIA |
Posted: Sat Feb 06, 2010 5:24 pm |
|
|
Joined: 26 Jan 2010
Posts: 2
Location: Sacramento CA
|
IS THERE ANYBODY CAN GIVE THE WRIGHT ANWSER ON THIS SUBJECT. WHEN I
GET DONE, TEXT TO ARC. BUT NOT WITH THE PROJECT HOW CAN I CHANGE
THE TEXT FROM GOING FROM ARC, THEN CHANGE BACK TO THE NORMAL TEXT
LIKE GOING STRAIGHT LINE. I ALLREADY KNOW HOW TO FROM TEXT TO PATH.
JUST NEED TO FROM ARC TO A STRAIGHT LINE. PLEASE HELP ME. |
_________________ THOMAS ODOM |
|
Back to top |
|
mark-s |
Posted: Sun Feb 07, 2010 5:24 am |
|
|
Joined: 13 Jan 2007
Posts: 32
Location: SO.CAL
|
The only thing I know is after you make your text to arc.
Copy to clipboard then back up a few steps until text is straight again.
Paste your arced text and proceed with the straight text.
Hope this helps.
mark-s |
|
|
Back to top |
|
mikie2000 |
Posted: Mon Mar 08, 2010 11:42 pm |
|
|
Joined: 02 Mar 2007
Posts: 6
|
The other way would be to duplaciate you text and then arc one and use the other one for your straight.Might be easer than tryin to change it back |
|
|
Back to top |
|
|