| Author |
Message |
< Vinyl Cutter sign making ~ Heat pressed ThermoFlex plus-wont pierce the vinyl |
| sportmarty |
 Posted: Sun Sep 03, 2006 5:11 am |
 |
|
|
Joined: 12 Aug 2006
Posts: 7
|
I am having a heck of a time with the blade height, pressure settings and speed settings. I keep reading that 100 should be a good pressure yet I was cutting at 147 on the vinyl that Pcut 900 came with. Now I have recieved my first roll of thermoflex plus and it is either does not pierce the vinyl or it penetrates too deep. I see my blade is sticking out a lot more so than I think it should. I managed to cut several standard vinyl even oracal 651 with the priort settings but now all is lost as I have changed the depth of the blade and pressure . Now I can cut any viny types at all
ANY help and suggestions ?
Thanks |
|
|
| Back to top |
 
|
| Pierre |
| Posted: Mon Sep 11, 2006 11:15 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
| I think you scrap your blade then use a new one. For thick material you will need 60 degree blade. |
|
|
| Back to top |
 
|
|
|
