| Author |
Message |
|
| John |
 Posted: Tue Jan 24, 2006 10:34 pm |
 |
|
|
Guest
|
| is there any way of getting a driver for WInPCSIGN 12 to run a creation pcut ct 900 ? i know we have seen a lot of comments about these machines on the sign board but i just wondered if anyone could help. |
|
|
| Back to top |
|
| Yvon |
| Posted: Tue Jan 24, 2006 10:37 pm |
|
|
|
Guest
|
| Inside WINPCSIGN 14 you have all driver for PCUT creation , SignMax make a very special function to optimize the cutting quality , i try with flexi and sign lab and the best quality for small letter with the PCUT is WINPCSIGN 14 . |
|
|
| Back to top |
|
| Mike |
| Posted: Tue Jan 24, 2006 10:39 pm |
|
|
|
Guest
|
PCUT don't have a standart HPGL language you need to use a specific driver because
the language of the pcut mix the HPGL and the DMPL |
|
|
| Back to top |
|
| Pierre |
| Posted: Tue Feb 07, 2006 9:49 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
| I don't find my driver in the winpcsign list. How to add new driver?? |
|
|
| Back to top |
   
|
| Pierre |
| Posted: Tue Feb 07, 2006 9:51 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
| Will this software work on both my Creation and my MASTER300 cutter? |
|
|
| Back to top |
|
| Gues |
| Posted: Sat Feb 11, 2006 2:26 pm |
|
|
|
Guest
|
if your cutter is not in the list ask signmax with a Email signmax@signmax.us
if your driver is not in the list signmax can add a driver for you |
|
|
| Back to top |
|
|
|
