Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  WinPCSIGN, error messages and solution  ~  WinPCSIGN Driver

John
Posted: Tue Jan 24, 2006 10:34 pm Reply with quote
Guest
is there any way of getting a driver for WInPCSIGN 12 to run a creation pcut ct 900 ? i know we have seen a lot of comments about these machines on the sign board but i just wondered if anyone could help.
Yvon
Posted: Tue Jan 24, 2006 10:37 pm Reply with quote
Guest
Inside WINPCSIGN 14 you have all driver for PCUT creation , SignMax make a very special function to optimize the cutting quality , i try with flexi and sign lab and the best quality for small letter with the PCUT is WINPCSIGN 14 .
Mike
Posted: Tue Jan 24, 2006 10:39 pm Reply with quote
Guest
PCUT don't have a standart HPGL language you need to use a specific driver because
the language of the pcut mix the HPGL and the DMPL
Pierre
Posted: Tue Feb 07, 2006 9:49 pm Reply with quote
Site Admin Joined: 24 Jan 2006 Posts: 151 Location: Montreal
I don't find my driver in the winpcsign list. How to add new driver??
View user's profile Send private message Send e-mail Visit poster's website
Pierre
Posted: Tue Feb 07, 2006 9:51 pm Reply with quote
Site Admin Joined: 24 Jan 2006 Posts: 151 Location: Montreal
Will this software work on both my Creation and my MASTER300 cutter?
View user's profile Send private message Send e-mail Visit poster's website
Gues
Posted: Sat Feb 11, 2006 2:26 pm Reply with quote
Guest
if your cutter is not in the list ask signmax with a Email signmax@signmax.us

if your driver is not in the list signmax can add a driver for you

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum