| Author |
Message |
|
| zzxxccvv |
 Posted: Mon Sep 03, 2007 12:36 pm |
 |
|
|
Joined: 11 Jul 2007
Posts: 3
|
Just upgraded to a Roland GX-24 (from a creation pcut 630) and boy - what a difference!!!!!
After cutting, the pcut would advance to the end of the cutting, so it was ready to cut a new job automatically - wonderful.
The Roland however, returns to the starting point, so I have to manually roll the vinyl forward.
Is there anyway of setting winpcsign to finish cutting at the end of the cut? |
|
|
| Back to top |
 
|
| Pierre |
| Posted: Thu Sep 06, 2007 6:04 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
Hi
YES!!! you need only select Advance from Cutting Control Panel |
|
|
| Back to top |
 
|
| zzxxccvv |
| Posted: Mon Sep 10, 2007 12:39 am |
|
|
|
Joined: 11 Jul 2007
Posts: 3
|
Thanks for the reply - I dont think I was specific enough in my previous post.
I DO select advance, but when cutting is finished. the Roland has advanced to the opposite SIDE of the cut job (ie it starts on the left side of the vinyl, and finishes on the right side of the vinyl), but the vinyl has not moved forward
In this image, 0 is the origin, 1 is where I want the head to finish, X is where the head ACTUALLY finishes - this is with the ADVANCE clicked.
If advance is not clicked, the heat ends at the origin - position 0
Any thoughts?? |
|
|
| Back to top |
|
| Pierre |
| Posted: Tue Sep 11, 2007 2:32 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
The Roland offer you 2 start point AXIS 0 and AXIS 90 We normally recommend to set on cutter itself Axis 90 This option give the start point on right corner (x0 y0 zero)
Thanks |
|
|
| Back to top |
|
|
|
