Signmax.us ~ View topic - Advancing Vinyl

Author

Message

< WinPCSIGN Software ~ Advancing Vinyl

stikas

Posted: Fri Mar 19, 2010 10:06 am

Joined: 17 Mar 2009 Posts: 8 Location: Australia

I just got delivered a GX300 Roland Plotter..
Everything works OK except when the machine finished cutting. The vinyl does not advance although it is checked in the Cutting Control Panel. Then I use sheet cut to cut the vinyl and end up cutting through the last letter, or the last 20mm of the drawing. Is there a command that I can put in to the END CMD field in plotter codes to rectify this.

_________________
If it aint a UTE I aint interested..

All times are GMT

View next topic View previous topic Page 1 of 1 Signmax.us Forum Index ~ WinPCSIGN Software

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum