| Author |
Message |
< WinPCSIGN Software ~ how do I use the "round corner" tool ?? |
| kerri eva |
 Posted: Wed Jun 16, 2010 1:05 am |
 |
|
|
Joined: 15 Jun 2010
Posts: 20
Location: Australia
|
I am trying to use the tool called "round corner". It's on the manipulation tool bar. Anyone know?
Cheers
Kerri eva |
|
|
| Back to top |
 
|
| J & S Racing |
| Posted: Fri Jul 02, 2010 5:44 am |
|
|
|
Joined: 21 Sep 2007
Posts: 24
|
| Did you figure this out? If so, did it work? |
|
|
| Back to top |
|
| stikas |
| Posted: Tue Jul 27, 2010 4:26 am |
|
|
|
Joined: 17 Mar 2009
Posts: 8
Location: Australia
|
Hi.
This is how it is done.
1 make box, rectangle.
2 select MOVE POINT TOOL
3 from the MOVE POINT TOLLBOX select ROUNDED CORNER TOOL (hold your cursor over it and it will tell you what it is.
4. using mouse click on a corner of the square. this will bring up a value box.
depending on the size of the curve you want this will determain the value. I usually use 0.5 for small curves, but this also depends on the size of the box.
one you have pressed ok the box you sellected should change. The click on the other corners. |
_________________
If it aint a UTE I aint interested.. |
|
| Back to top |
 
|
|
|
