| |
| Author |
Message |
|
| Pete |
 Posted: Tue Jan 24, 2006 11:44 pm |
 |
|
|
Guest
|
To cut with the correct orientation, most Roland cutters need to be set to the Rotate mode. The information below provides basic information about configuring different Roland cutters and is provided as a guide only. You should always consult the documentation supplied with your cutter.
Model Instruction
PNC-1000 Set the Size to Expand-X
PNC-1000A, 1100, 1200, 1210
1410, 1800, 1810, 1850, 1860 Set Rotate function to RO-90
PNC-900, 910, 950, 960 Press the Rotate button on the front panel each time you power on.
CM-12, 24 Press the Rotate button on the front panel each time you power on.
CM-300, 400, 500 Set Rotate function to RO-90
CX-12, 24 Set DIP switch to Rotate |
|
|
| Back to top |
|
|
|
All times are GMT
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
