| Author |
Message |
|
| BaiCam |
 Posted: Sat Aug 19, 2006 9:18 am |
 |
|
|
Joined: 18 May 2006
Posts: 16
|
| in engrave mode can you set a tool path i.e. for fills other than the letters for reverse engraving routering ,is there different tool cut paths to select i.e. s sweep fills etc thanks |
|
|
| Back to top |
   
|
| Pierre |
| Posted: Wed Aug 23, 2006 2:53 pm |
|
|
|
Site Admin
Joined: 24 Jan 2006
Posts: 151
Location: Montreal
|
Yes you can manage many tool path direction. You have a sweet fill. See the panel for the engraving.
 |
|
|
| Back to top |
|
| BaiCam |
| Posted: Wed Aug 23, 2006 4:06 pm |
|
|
|
Joined: 18 May 2006
Posts: 16
|
| Where in winPCSIGN is the Engraving panel? |
|
|
| Back to top |
|
| BaiCam |
| Posted: Wed Aug 23, 2006 4:10 pm |
|
|
|
Joined: 18 May 2006
Posts: 16
|
| I have found that but are there any other instructions for Engraving anywhere? |
|
|
| Back to top |
|
|
|
