Welcome to Signmax.us Forum
WinPCSIGN BASIC - PRO Welcome to Signmax.us Forum
Author Message

<  WinPCSIGN, error messages and solution  ~  each graphic does not completely cut

jechambe
Posted: Tue Apr 24, 2007 6:00 pm Reply with quote
Joined: 18 Nov 2006 Posts: 2
hi, i have been using winpcsign letter 2005 for the past 2 years. since day one i have always had a little bit of material that remains uncut on each piece i cut. i have to go over it with an exacto knife to complete it. its always in the spot where the cut started for that object. it seems the plotter just does not completely finish each cut. the uncut portion is less than 1mm wide, sometimes just a hairs width. plotter is the CT635 and the test cuts run on the machine do not exhibit this problem. fresh 45 degree blade carbide tip. does this on calendered and cast vinyl consistently.

cutting control panel settings:
Advance is checked

cutting & engraving options settings:
Weed Value 0.15
Curve Resolution 5
Knife Offset 12
Start Point Orientation Checked

thanks in advance for anyone that can help me solve this!
View user's profile Send private message
Yelena
Posted: Tue Apr 24, 2007 6:40 pm Reply with quote
Joined: 17 Apr 2007 Posts: 6
Try knife offset 15-20, if result will the same, try 0 Knife Offset.
If no changes - update your programme.
View user's profile Send private message

Display posts from previous:  

All times are GMT
Page 1 of 1
Post new topic

Jump to:  

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum