| Author |
Message |
|
| yes_r_no |
 Posted: Wed May 02, 2007 12:49 pm |
 |
|
|
Joined: 25 Apr 2007
Posts: 2
|
| Im new to using a plotter. I have looked through the post and still cannot find any that tell you how to load your material. Do you load it in the front or back? Does it cut from left to right or right to left? Any help is appreciated! |
|
|
| Back to top |
 
|
| westrop |
| Posted: Fri May 11, 2007 11:49 am |
|
|
|
Joined: 11 Mar 2007
Posts: 10
|
Hello,
A plotter uses its material from the back to the front (or you must bi on the wrong site  ). The cutting is how you wil draw the line in the cuttingsoftware. If you draw it from left to right than it wil cut the same way.
Good luck
Rob van Westrop
Holland |
|
|
| Back to top |
|
|
|
