| Author |
Message |
< WinPCSIGN Software ~ Problem with WinPCSIGN and Roland PNC-1000 communicating |
| mark |
 Posted: Fri Sep 23, 2011 3:31 pm |
 |
|
|
Joined: 21 Sep 2011
Posts: 1
|
I followed your instructions and I believe the 2 are communicating now but the read-out on the Roland screen says "ESC. Error 16 Please see manual" - but my manual doesn't name error 16 and tell me the fix. However, I did find a manual of a PNC-900 on line from an that states "Cause: the I/O buffer overflows. Action: This error does not occur when hardware handshake is performed, but may occur when software handshake is performed. If this error occurs, check the remaining buffer capacity of the PNC-900 and send less data than the remaining buffer capacity".
Hope you can help.
One more thing. I pressed the FUNC key after the message appeared and the cutter carriage moved over to the left and cut part of the image I sent to be cut. |
|
|
| Back to top |
 
|
| Ivan |
| Posted: Tue Sep 27, 2011 5:23 pm |
|
|
|
Joined: 19 Apr 2007
Posts: 352
Location: Montreal
|
You need to contact Roland company
http://www.rolanddga.com/ |
Last edited by Ivan on Wed Sep 28, 2011 1:17 pm; edited 1 time in total
_________________
Ivan Polanco, Sales manager/Support
Signmax.us Profesionnal signmaking ressources |
|
| Back to top |
 
|
|
|
